Good Heat Dissipation: The air cooling model and multiple cooling holes on the body can timely reduce the temperature of the product in the process of operation, and avoid potential safety hazards, thus extending the product's service life. Sturdy & Reliability: It features a commercial grade unit, toughened crankshaft, ball bearing construction, accurate thumb throttle control, and a high tensile gear set, so this item can realize maximum reliability. Large Capacity: 1.3L/54.95oz oil tank avoids frequent refueling and improves working efficiency. Elaborate Design: This product is mainly powered by gasoline without wire limitation, which provides more convenience for you to use outdoors. Simple Installation and Use: The simple structure, detailed manual, ergonomic, anti-slip, and shock-absorbing double handles, starting device, and complete accessories ensure that you can complete the installation and start using it in a short time.
Complete Kit: The combination of an oil feeder, two chisels, an installation kit, etc. Effortless Cleaning: The smooth surface allows you to easily remove dust and residues with a towel and water.
Round Corners: Compared with traditional square corners, an arc design can better care for your skin. Two Chisels: Two chisels of different shapes allow wider application, and it is also convenient for you to replace. Oil Filler: The filler with a large opening is convenient for you to add oil in time. This product is suitable for on-site work without a power supply or under wet conditions, such as foundation removal, lane removal, reinforced concrete floor or wall removal, penetrating hard rock, asphalt removal, trenching operation, driving grounding rod, farmland fence, and highway guardrail piling, etc. It is also suitable for the compaction of loose material if suitable parts are connected.Engine Type: 4434mm/17.3213.39inch Air-Cooled Single-Cylinder Two-Stroke. Ratio: 25: 1(92#Gasoline: Motor Oil). Fuel Tank Capacity: 1.3L/54.95oz. Power And Speed:1.9kw/6500r/min. Torque And Speed:3.5Nm/5000r/min.
Starter System: Hand Pull Start. Product Size: 402795cm/15.7510.6237.4inch. Chisel Type: Pin Card Type (Without Thread) 28400mm (1.115.75inch). Please install and use it in strict accordance with the instructions, and pay attention to the safety precautions inside. After each use, please check the tightness of the screws in oil filler. Please use butter and add it to the oil eye. After 20 hours of use, please add 30-50g of butter. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before ordering. Feedback is very important to us.It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business.
A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday.