32.6CC 2-Stroke Gas Powered Concrete Breaker Punch Drill Demolition Jack Hammer
32.6CC 2-Stroke Gas Powered Concrete Breaker Punch Drill Demolition Jack Hammer. The hammer machine is made of premium aluminum and plastic with high strength.
The three functions (hammer/drill/pick) can meet your various needs and the powerful engine can promote your efficient work. It is an ideal choice for electricians, carpenters, etc. The two-stroke engine with high power (1200W) and large displacement (32.6CC), as well as an enlarged thick-walled cylinder, can achieve a high impact frequency (3200min-1) and impact energy (30J) to easily and quickly penetrate concrete, bricks, rocks, etc with a high speed (5000rpm). Equipped with three drill bits and two different chisels, it can be used for hammer, drill, or pick by adjusting the knob on the side to meet your diversified needs.
The built-in carburetor can fully atomize fuel to decrease its consumption rate to save costs. The built-in air filter can well filter impurities in. To reduce engine consumption and extend its service life. Aluminum material with a painted process is glossy and can. T wear, corrosion, and heat.
Meanwhile, the plastic material is. Design and light weight can improve the flexibility of operation. You can pull the rope to start the machine.
Besides, the throttle switch, one-button flameout switch, and. Auxiliary handle allow for convenient use. The collet adopts a clamping design to prevent the drill bit or chisel from falling off.We aim to provide quality products and services. We will reply and solve the problem for you as soon as possible. The heat dissipation holes on the sides can dissipate heat in time and prolong the service life of this product. The large fuel tank (0.9L) can avoid frequent adding.
Meanwhile, the semi-translucent design is convenient for you to observe the remaining fuel quantity and add fuel in time. The internal silencer can reduce the noise (? 104dB) when in use to protect your hearing. This applies to drilling holes in concrete, floors, brick walls, stones, and solid walls. It is suitable for electricians and carpenters. It is suitable for crushing, chiseling, digging, grooving, cutting, and other operations on concrete, masonry structure, and asphalt pavement.Engine Type: Single Cylinder, Air Cooling, 2-stroke. Max Torque and Speed: 1.5N. Fuel Mixture Ratio: 25:1. Fuel Tank Capacity: 0.9L/0.2gal/30Oz. 0.5L/0.1gal/16Oz Per Hour.
Max Drilling Diameter: 40mm/1.5inch. Starter System: Hand Pull Start.
Net Weight (Exclude Drill): About 10.5kg/23lbs. Point Chisel Size: 18350mm/0.713inch. Put in a drill bit or chisel. Before each use, please check whether the oil bubble is full of oil.If the oil is not enough, you need to press the carburetor until the oil is full. It is best to press the carburetor every time you use it. Please replace the air filter sponge after 36 hours of continuous operation to avoid damage to the engine cylinder.
Please clean up the oil in the carburetor if it is not used for a long time. The carburetor does not need to be replaced if it can be used normally. Please add lubricating oil regularly to ensure strong power. Please do not touch the muffler exhaust hole to avoid scalding. And engine oil is generally 25:1, but due to the difference of engine oil quality in different regions, we recommend the ratio of 20:1.Please do not use cheap inferior engine oil. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before ordering.